You will see that three macros are created. One macro is named after your server's host name, and it contains the settings specified as system-wide settings with the first dhcpconfig command. Another macro has the name of the network you just created, and it contains the settings entered in the last command. The last macro named Locale simply holds timezone information, with a setting claiming the amount of seconds your local timezone differs from UTC. As you can see from the output, the current time server is set to So we are going to correct that to We are also going to alter the The last command used to configure the DHCP server is pntadm , which sets up settings for each host on the network.
Should be prepended with 01 to specify that this is an Ethernet address. Cerrar sugerencias Buscar Buscar. Saltar el carrusel. Carrusel anterior. Carrusel siguiente. Explora Audiolibros. Explora Revistas. Explora Podcasts Todos los podcasts. Dificultad Principiante Intermedio Avanzado.
Explora Documentos. Cargado por halachwinic. Compartir este documento Compartir o incrustar documentos Opciones para compartir Compartir en Facebook, abre una nueva ventana Facebook. Denunciar este documento. Marcar por contenido inapropiado. Descargar ahora. Carrusel anterior Carrusel siguiente. Buscar dentro del documento. Documentos similares a manual dhcp opensolaris. Robertson Santander. Pako Cruz. Antonio Carrillo. Carmen Jama. Rlm Loredo. Marvin Edu Toledo Castro. Diana HernaNdez. This feature enables you to power on the server from another location over the network.
The following procedure describes how to boot the OpenSolaris It assumes that you are booting the installation media from one of the following sources:. Prior to performing the installation, the following requirements must be met:. Note that the following procedure explains the initial steps for booting the installation media and launching the OpenSolaris installation program.
After completing this procedure, you should review and perform the required post installation tasks described later in this chapter. Ensure that the installation media is available to boot. The Please Select Boot Device menu appears. The device strings listed on the Boot Device menu are in the format of:. The system loads the OpenSolaris disk image into memory. This process can take several minutes. The system discovers and configures the devices and interfaces.
If the system discovers a keyboard, the Configure Keyboard Layout menu appears. In the Configure Keyboard Layout menu, select the appropriate keyboard layout, then press Enter to continue. The system configures the keyboard layout selection and searches for configuration files. The Select Desktop Language menu appears. In the Select Desktop Language menu, select the appropriate desktop language, then press Enter to continue.
After a few moments the OpenSolaris The OpenSolaris Installer Welcome screen appears. In the Welcome screen, click Next to begin the installation. The OpenSolaris installation program will display several configuration screens.
Follow the on-screen instructions to complete the OpenSolaris installation. For additional information, refer to the Getting Started with OpenSolaris After completing the OpenSolaris installation and rebooting the Operating System, review the following post installation tasks and, if necessary, perform the tasks that are applicable to your system.
0コメント